ParametersParameter DescriptionrepositoryRAIDLevel The RAID level for the replication repository virtualdisk. Valid values are 0, 1, 5, or 6.repositoryPhysicalDisks The physical disks for the replication repositoryvirtual disk. For high-capacity expansionenclosures, specify the enclosure ID value, thedrawer ID value, and the slot ID value for eachphysical disk that you assign to the replicationrepository virtual disk. For low-capacity expansionenclosures, specify the enclosure ID value and theslot ID value for each physical disk that you assignto the replication repository virtual disk. EnclosureID values are 0 to 99. Drawer ID values are 0 to 4.Slot ID values are 0 to 31. Enclose the enclosure IDvalues, the drawer ID values, and the slot ID valuesin parentheses.repositoryDiskGroupUserLabel The name that you want to give the new diskgroup in which the replication repository virtualdisk is located. Enclose the disk group name indouble quotation marks (" ").repositoryDiskGroup The name of the replication repository disk groupwhere the replication repository virtual disk islocated. (To determine the names of the diskgroups in your storage array, run the showstorageArray profile command.)freeCapacityArea The index number of the free space in an existingdisk group that you want to use to create thereplication repository virtual disk. Free capacity isdefined as the free capacity between existingvirtual disks in a disk group. For example, a diskgroup might have the following areas: virtual disk 1,free capacity, virtual disk 2, free capacity, virtualdisk 3, free capacity. To use the free capacityfollowing virtual disk 2, you would specify:freeCapacityArea=2Run the show diskGroup command to determineif a free capacity area exists.repositoryPhysicalDiskCount The number of unassigned physical disks that youwant to use for the replication repository virtualdisk.enclosureLossProtect The setting to enforce enclosure loss protectionwhen you create the replication repository virtualdisk. To enforce enclosure loss protection, set thisparameter to TRUE. The default value is FALSE.drawerLossProtect The setting to enforce drawer loss protectionwhen you create the replication repository virtualdisk. To enforce drawer loss protection, set thisparameter to TRUE. The default value is FALSE.134
