Recopy Virtual Disk CopyDescriptionThis command reinitiates a virtual disk copy operation by using an existing virtual disk copy pair.NOTE: See Preparing Host Servers To Recopy A Virtual Disk.CAUTION: Before you create a new copy of a source virtual disk, stop any data access (I/O)activity or suspend data transfer to the source virtual disk and (if applicable, the target disk) toensure that you capture an accurate point-in-time image of the source virtual disk. Close allapplications, including Windows Internet Explorer, to make sure all I/O activity has stopped.NOTE: Removing the drive letter of the associated virtual disk(s) in Windows or unmounting thevirtual drive in Linux helps to guarantee a stable copy of the drive for the virtual copy.Syntaxrecopy virtualDiskCopy target [targetName][source [sourceName]][copyPriority=(highest | high | medium | low | lowest)targetReadOnlyEnabled=(TRUE | FALSE)]copyType=(online | offline)ParametersParameter Descriptiontarget Name of the target virtual disk for which toreinitiate a virtual disk copy operation. You mustput brackets ([ ]) around the target virtual diskname. If the target virtual disk name has specialcharacters, you must also put quotation marks (" ")around the target virtual disk name.source Name of the source virtual disk for which toreinitiate a virtual disk copy operation. You mustput brackets ([ ]) around the source virtual diskname. If the source virtual disk name has specialcharacters, you must also put quotation marks (" ")around the source virtual disk name.copyPriority Specifies the priority that the virtual disk copy hasrelative to host I/O activity. Valid entries arehighest, high, medium, low, or lowest.228
