Parameter DescriptionhostTypeTable command to generate a list ofavailable host type identifiers.host Specifies the name of the host connected to theRAID controller modules. You must put quotationmarks (" ") around the host name.NOTE: Use the show controller NVSRAM command to display parts or all of the NVSRAM beforeusing the set controller command to change NVSRAM values.Show Remote Replication GroupDescriptionThis command displays configuration information for one or more remote replication groups. Thiscommand also displays the remote replicated pairs associated with each remote replication group,including incomplete remote replicated pairs.You can also use this command to show the progress of periodic data synchronization on all of thereplicated pairs within the remote replication group.Syntaxshow (allAsyncRemoteReplicationGroups |asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"])[summary]ParametersParameter DescriptionallAsyncRemoteReplicationGroups Use this parameter if you want to display theproperties for all remote replication groups.asyncRemoteReplicationGroup Use this parameter to display the properties for aremote replication group. Enclose the remotereplication group name in square brackets ([ ]). Ifthe remote replication group name has specialcharacters, you also must enclose the remotereplication group name in double quotation marks(" ") inside square brackets. If the remote replicationgroup name consists only of numbers, such as"1002," you also must enclose the remotereplication group name in double quotation marks(" ") inside square brackets.summary Use this optional parameter to show a concise listof information about the synchronization progressof one or more remote replication groups.331
