Set Storage Array Learn CycleDescriptionThis command sets the learn cycle for the battery backup unit. The learn cycle enables the MD storagemanagement software to predict the remaining battery life. Learn cycles run at set intervals and store theresults for software analysis.Syntaxset storageArray learnCycleDate(daysToNextLearnCycle=numberOfDays |day=dayOfTheWeek) time=HH:MMParametersParameter DescriptiondaysToNextLearnCycle Valid values are 0 through 7, where, 0 isimmediately and 7 is in seven days. ThedaysToNextLearnCycle parameter takes placeup to seven days after the next scheduled learncycle.day Valid values for the day parameter include the daysof the week. Setting the day causes the next learncycle to be scheduled on the specified day, afterthe currently scheduled learn cycle.time The time in 24-hour format; for example 8:00 a.m.is entered as 08:00. Nine o’clock p.m. is entered as21:00, and 9:30 p.m. is entered as 21:30.NOTE: You can set the learn cycle to occur only once during a seven-day period. The timeparameter selects a specific time that you want to run the learn cycle. If a value is not entered, thecommand uses a default value of 00:00 (midnight). If the day and time specified are in the past, thenext learn cycle takes place on the next possible day specified.Set Storage Array Redundancy ModeDescriptionThis command sets the redundancy mode of the storage array to either simplex or duplex.Syntaxset storageArray redundancyMode=(simplex | duplex)307
