ParametersParameter Descriptionsource Name of an existing virtual disk to use as thesource virtual disk. You must put quotation marks ("") around the source virtual disk name.NOTE: You can use any combination ofalphanumeric characters, hyphens, andunderscores for the names. Command namescan have a maximum of 30 characters. If youexceed the maximum character limit, replacesquare brackets ([ ]) with angle brackets (< >)to overcome this limitation.target Name of an existing virtual disk to use as the targetvirtual disk. You must put quotation marks (" ")around the target virtual disk name.NOTE: You can use any combination ofalphanumeric characters, hyphens, andunderscores for the names. Command namescan have a maximum of 30 characters. If youexceed the maximum character limit, replacesquare brackets ([ ]) with angle brackets (< >)to overcome this limitation.copyPriority Specifies the priority that a virtual disk copy hasrelative to host I/O activity. Valid entries arehighest, high, medium, low, or lowest.NOTE: CopyPriority defines the amount ofsystem resources used to copy the databetween the source virtual disk and targetvirtual disk of a virtual disk-copy pair. If youselect the highest priority level, the virtual diskcopy uses the most system resources toperform virtual disk copy, which decreasesperformance for host data transfers.targetReadOnlyEnabled Specifies whether the target virtual disk is writeenabled or read only. To be able to write to thetarget virtual disk, set this parameter to FALSE. Toprevent writing to the target virtual disk, set thisparameter to TRUE.copyType Creates a virtual disk copy with or a snapshot(legacy). Creating a virtual disk copy with asnapshot (legacy) enables you to continue to writeto the source virtual disk while creating the virtualdisk copy. To create a virtual disk copy with a198
