ParametersParameter DescriptionvirtualDisk or virtualDisks The name of the specific virtual disk for which youwant to define properties. (You can enter morethan one virtual disk name if you use thevirtualDisks parameter.) Enclose the virtual diskname in double quotation marks (" ") inside ofsquare brackets ([ ]).virtualDisk The World Wide Identifier (WWID) of the virtual diskfor which you are setting properties. You can usethe WWID instead of the virtual disk name toidentify the virtual disk. Enclose the WWID in anglebrackets (< >).newCapacity Increase the virtual capacity of the thin virtual disk.This is the value that the virtual disk will report to ahost that is mapped to the virtual disk. Valuessmaller or equal to the existing capacity will causean error.NOTE: The maximum capacity is 250 GB.repositoryMaxCapacity Set the maximum capacity of the repository virtualdisk. The value must not be smaller that thephysical capacity of the repository virtual disk. Ifthe new value results in a reduction in capacity to alevel below the warning threshold, the commandwill produce an error.repositoryExpansionPolicy Set the expansion policy to automatic or manual.When you change the policy from automatic tomanual, the maximum capacity value (quota)changes to the physical capacity of the repositoryvirtual disk.warningThresholdPercent Adjust the warning threshold. If a change to thisvalue would cause a warning condition, thecommand will fail and produce an error.addRepositoryCapacity Allocate capacity from the free extent of the diskpool. If insufficient space is available the commandfails.NotesWhen you use this command, you can specify one or more of the optional parameters.310
