Syntaxset diskGroup [diskGroupName] forcedStateParametersParameter DescriptiondiskGroup Sequence number of the disk group for which toset properties. You must put brackets ([ ]) aroundthe disk group number.NOTE: You can move the physical disks that comprise a disk group from one storage array toanother storage array. The CLI provides three commands that let you move the physical disks. Thecommands are start diskGroup export, start diskGroup import, and set diskGroupforcedState. In the Forced state, you can perform an import operation on the disk group.Set Disk PoolDescriptionThis command sets the attributes associated with a disk pool based on the specified parameters.Syntaxset diskPool(diskPool=[diskPoolName] | diskPools=[diskPoolName1... diskPoolNamen] |allDiskPools)[reservePhysicalDiskCount=reservePhysicalDiskCountValue |warningThreshold=(warningThresholdValue | default) |criticalThreshold=(criticalThresholdValue | default) |criticalPriority=(highest|high|medium|low|lowest) |backgroundPriority=(highest|high|medium|low|lowest) |degradedPriority=(highest|high|medium|low|lowest)userLabel=diskPoolName]ParametersParameter DescriptiondiskPools The list of diskPoolNames identifies multiplephysical disk pool which have their parametersreset by the command.allDiskPools This parameter specifies that all physical disk poolshave their parameters reset by the command.reservePhysicalDiskCount This value is specified in terms of the number ofphysical disks to reserve in the disk pool forphysical disk failures or physical disk removals.warningThreshold The percentage of disk pool capacity at which youreceive a warning alert that the disk pool is nearing273
