host=”newHostName” |chapSecret=”newSecurityKey”)ParametersParameter DescriptioniscsiID The name of the iSCSI initiator for which you want toset attributes.userLabel The new name that you want to use for the iSCSIinitiator.host The name of the new host to which the HBA hostport is connected. Enclose the host name in doublequotation marks (" ").chapSecret The password that you want to use to authenticate apeer connection.NOTE: Challenge Handshake Authentication Protocol (CHAP) is a protocol that authenticates thepeer of a connection. CHAP is based upon the peers sharing a “secret.” A secret is a security key thatis similar to a password.NOTE: Use the chapSecret parameter only for initiators requiring mutual authentication.Set iSCSI Target PropertiesDescriptionThis command defines properties for an iSCSI target.Syntaxset iscsiTarget [“iscsiID”](authenticationMethod=(none | chap) |chapSecret=”securityKey” |targetAlias=”userLabel”)ParametersParameter DescriptioniSCSIID The iSCSI target for which you want to setproperties. Enclose the name in double quotationmarks (“ ”). You must also enclose the iscsi ID ineither square brackets ([ ]) or angle brackets (< >).authenticationMethod The means of authenticating your iSCSI session.chapSecret The password that you want to use to authenticatea peer connection.targetAlias The name that you want to use for the target.280
