Eaton Network-M3 User Manual

SettingsContextual help of the web interface – 1163.7.5.4.2 DHCPSelect DHCP and Save the configuration.3.7.5.5 CLI commandsnetconfDescriptionTools to display or change the network configuration of the card.HelpFor Viewer and Operator profiles:netconf -hUsage: netconf [OPTION]...Display network information and change configuration.-h, --help display help page-l, --lan display Link status and MAC address-4, --ipv4 display IPv4 Mode, Address, Netmask and Gateway-6, --ipv6 display IPv6 Mode, Addresses and Gateway-d, --domain display Domain mode, FQDN, Primary and Secondary DNSFor Administrator profile:netconf -hUsage: netconf [OPTION]...Display network information and change configuration.-h, --help display help page-l, --lan display Link status and MAC address-d, --domain display Domain mode, FQDN, Primary and Secondary DNS-4, --ipv4 display IPv4 Mode, Address, Netmask and Gateway-6, --ipv6 display IPv6 Mode, Addresses and GatewaySet commands are used to modify the settings.-s, --set-lan speed>Link speed values:auto Auto negotiation10hf 10 Mbps - Half duplex10ff 10 Mbps - Full duplex100hf 100 Mbps - Half duplex100ff 100 Mbps - Full duplex1000ff 1.0 Gbps - Full duplex-f, --set-domain hostname set custom hostname-f, --set-domain Mode values:- set custom Network address, Netmask and Gateway:manual name> - automatically set Domain name, Primary and Secondary DNSdhcp-i, --set-ipv4