Eaton Network-M3 User Manual

Device detailsContextual help of the web interface – 151•••••••••3.8.3 Settings - ATSAudible alarm - To enable / disable the sound emitted by the UPS when an alarm is triggered ( Battery replacement alarm forinstance or UPS technical fault )Prefered source – To set the priority on Source 1 or Source 2 (Source 1 by default).Sensitivity – To set the sensitivity mode for input mains detectionNormal sensitivity by defaultLow sensitivity for compatibility with distorted waveformHigh sensitivity when the load demands higher power stabilityLIA UPS Input when the power source of the ATS is a Line Interactive UPSTransfer mode – To set the transfer mode between sources (Standard by default with no additional break even if sources areno synchronized, Gap with additional break during transfer if sources are not synchronized).Nominal voltage – To set voltage thresholds.3.8.3.1 Specifics3.8.3.2 Access rights per profilesAdministrator Operator ViewerATS3.8.3.2.1 For other access rightsThis section is only for the ATS device and contains all its settings.Device unique attributesSome options proposed may not apply to your device. Please refer to the device User Manual Guide.For other access rights, see the Information>>>Access rights per profiles section.