Eaton Network-M3 User Manual

Default settings and possible parametersInformation – 235••••••••SNMP Activate SNMP — disabledPort — 161SNMP V1 — disabledCommunity #1 — publicEnabled — InactiveAccess — Read onlyCommunity #2 — privateEnabled — InactiveAccess — Read/WriteSNMP V3 — enabledUser #1 — readonlyEnabled — InactiveAccess — Read onlyAuthentication — Auth (SHA-1)Password — emptyConfirm password — emptyPrivacy — Secured - AESKey — emptyConfirm key — emptyUser#2 — readwriteEnabled — InactiveAccess — Read/WriteAuthentication — Auth (SHA-1)Password — emptyConfirm password — emptyPrivacy — Secured - AESKey — emptyConfirm key — emptyActivate SNMP — disable/enablePort — x-xxxSNMP V1 — disable/enableCommunity #1 — 128 charactersmaximumEnabled — Inactive/ActiveAccess — Read onlyCommunity #2 — 128 charactersmaximumEnabled — Inactive/ActiveAccess — Read/WriteSNMP V3 — disable/enableUser #1 — 32 characters maximumEnabled — Inactive/ActiveAccess — Read only/Read-WriteAuthentication — Auth (SHA-1)/NonePassword — 128 characters maximumConfirm password — 128 charactersmaximumPrivacy — Secured - AES/NoneKey — 128 characters maximumConfirm key — 128 characters maximumUser#2 — 32 characters maximumEnabled — Inactive/ActiveAccess — Read only/Read-WriteAuthentication — Auth (SHA-1)/NonePassword — 128 characters maximumConfirm password — 128 charactersmaximumPrivacy — Secured - AES/NoneKey — 128 characters maximumConfirm key — 128 characters maximumTrap receivers No trap Enabled — No/YesApplication name — 128 characters maximumHostname or IP address — 128 characters maximumPort — x-xxxProtocol — V1/V2C/V3Trap community — 128 characters maximumDefault settings and possible parameters - CertificateDefault setting Possible parameters