Eaton Network-M3 User Manual

Checking the current firmware version of the Network ModuleServicing the Network Management Module – 189•••2. Enable the "Keep shutdown sequence running until the end and then restart (forced reboot)".3. Enable the "Automatically restart the UPS when battery capacity exceeds" and set it to 0%.The storage will restart first, right after utility recovery without waiting the battery capacity to exceed a % limit.4. Set Then Group 1 after to 120s.The database servers will restart 120s after the utility recovery.5. Set Then Group 2 after to 60s.The database servers will restart 180s after the utility recovery.4.4 Checking the current firmware version of the Network ModuleCurrent firmware of the Network Module can be accessed in :The Top bar: Firmware version: x.xx.xThe Card menu : Contextual help>>>Maintenance>>>System information>>>Firmware information: Version x.xx.xThe Card menu : Contextual help>>>Maintenance>>>Firmware: Active FW version x.xx.x4.5 Accessing to the latest Network Module firmware/driver/scriptDownload the latest Network Module firmware, driver or script from the Eaton website www.eaton.com/downloads4.6 Upgrading the card firmware (Web interface / shell script)4.6.1 Web interfaceTo upgrade the Network module through the Web interface, refer to the section: Firmware upgrade through the Web interface.4.6.2 Shell script4.6.2.1 PrerequisiteShell script uses the following tools: sshpass, scp.To get it installed on your Linux host, use the following commands.For instructions on accessing to the latest firmware and script, refer to: Accessing to the latest firmware and script