Eaton Network-M3 User Manual

SNMP trapsInformation – 2657.5.6.2.2 CommunicationCode Severity Active message Non-active message Advice1300 Info Communication: No device connected Communication: Communication with the device is back -1301 Info Communication: Device not supported Communication: Communication with the device is back -7.5.6.2.3 AlarmsCode Severity Active message Non-active message Advice1302 Info Alarms: the number of alarms ishigh and above 5 000Alarms: the number of alarms isback to normalIt is recommended toExport and Clear the alarmlog.7.6 SNMP traps7.6.1 UPS Mib7.6.1.1 IETF Mib-2 Ups trapsThis information is for reference only.Trap oid :.1.3.6.1.2.1.33.2.0.xDescription :.1.3.6.1.2.1.33.2.0.1 Sent whenever the UPS transfers on battery,then sent every minutes until the UPS Comes back to AC Input..1.3.6.1.2.1.33.2.0.3 Sent whenever an alarm appears.The matching alarm oid is added as bound variables in the table below..1.3.6.1.2.1.33.2.0.4 Sent whenever an alarm disappears.The matching alarm oid is added as bound variables in the table below.Alarm oid at :.1.3.6.1.2.1.33.1.6.3.xDescription when trap 3 Description when trap 4.1.3.6.1.2.1.33.1.6.3.1 Battery test failed Battery test OK.1.3.6.1.2.1.33.1.6.3.2 Battery discharging End of UPS battery discharge.1.3.6.1.2.1.33.1.6.3.3 Low battery Battery OK.1.3.6.1.2.1.33.1.6.3.5 Temperature alarm Temperature OK.1.3.6.1.2.1.33.1.6.3.6 Input AC not present Input AC present