Eaton Network-M3 User Manual

How do I log in if I forgot my password?Troubleshooting – 290••8.5.1.3 Action #1-21- Check the EMPs connection and cables.Refer to the sections Servicing the EMP>>>Installing the EMP>>>Cabling the first EMP to the device and Servicing theEMP>>>Installing the EMP>>>Daisy chaining 3 EMPs.2- Disconnect and reconnect the USB to RS485 cable.3- Launch the discovery, if it is still not ok, go to Action #1-3.8.5.1.4 Action #1-31- Reboot the Network module.2- Launch the discovery.8.5.2 Symptom #2The EMPs orange RJ45 LEDs are not blinking.8.5.2.1 Possible causesC#1: the EMP address switches are all set to 0.C#2: the EMPs are daisy chained, the Modbus address is the same on the missing EMPs.8.5.2.2 Action #2-11- Change the address of the EMPs to have different address and avoid all switches to 0.Refer to the section Servicing the EMP>>>Defining EMPs address and termination>>>Manual addressing.2- Disconnect and reconnect the USB to RS485 cable. The address change is only taken into account after an EMP power-up.3- Launch the discovery, if it is still not ok, go to Action #2-2.8.5.2.3 Action #2-21- Reboot the Network module.Refer to the section Contextual help>>>Maintenance>>>Services>>>Reboot.2- Launch the discovery.8.6 How do I log in if I forgot my password?8.6.1 ActionAsk your administrator for password initialization.If you are the main administrator, your password can be reset manually by following steps described in the Servicing theNetwork Management Module>>>Recovering main administrator password.