Appendix C—Optional Communication CardsPower Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 235Note: To use Bit 2 in Output Instances 106, 127, 128 and 129 to switch the Active Controlsource between Local (0) and Remote (1), the “Allow Remote Control Switch” mustbe Enabled (True). This parameter can be found in the Operation Mode category,under Advanced Parameters.Output Instance 105 (0x69): Basic Output ControlLength = 2 BytesByteOffsetSize(bytes) Name Description0 2 Basic Overloadw/RelayBasic Overload with RelaysBit 0 = Output #1Bit 1 = Output #2Bit 2 = Output #3 (set)Bit 3 = Fault ResetBit 4 = Output #3 (reset)Bit 5 = Test TripBit 6 to 15 = reservedOutput Instance 106 (0x6A): Extended Motor Control 2Length = 2 BytesByteOffsetSize(bytes) Name Description0 2 Basic Control Relay Basic Control Bits:(Byte1: NETCTRL_CONTROL_WORD)(Byte2: BCM_FIELD_OUTPUTS)Bit 0: Run1Bit 1: Run2Bit 2: Switch Control to Remote (see note below)Bit 3: Fault ResetBit 4: Control from network / Switch to remoteBit 5: Test TripBit 6: ReservedBit 7: ReservedBit 8: Output #1 (Conditional. Depends on profile selected)Bit 9: Output #2 (Conditional. Depends on profile selected)Bit 10: Output #3 (set) (Conditional. Depends on profile selected)Bit 11: Output #3 (reset) (Conditional. Depends on profile selected)Bits 12–15: ReservedOutput Instance 123 (0x7B): Basic Starter Relay with Analog and Digital OutputsLength = 8 BytesByteOffsetSize(bytes) Name Description0 2 Basic Starter withAnalog and DigitalOutputsVendor specific Basic starterBit 0 = Run1Bit 1 = Run2Bit 2 = ReservedBit 3 = Fault ResetBits 4 to 15 = Reserved2 2 Digital Outputs Bits 0-7 = Outputs for first digital output cardBits 8-15 = Outputs for second digital output card4 4 Analog Outputs 2 Output words of data for 2 analog outputs
