Appendix D—Modbus Register Map328 Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com718 Q3 Latch Reset UINT16 RW NVDefault: 57EnumConfig CRCRun LockAdmin LockUSB LockBackup MemOutput Reset Function Select for General Purpose Output 3. Availablewhen this output is not used by the Operation Mode and only whenOutput 3 is a latching relay. Default = none, If used by the ApplicationMode = Reserved. (For latching relay, 0 = no change and 1 = reset). A softreset is required after modifying this parameter.Table 128. C445 Modbus Register Map, continuedRegister Name Attribute DescriptionValue Description0 None1 Fault Reason Type - Load fault (Power based)2 Fault Reason Type - Supply fault (Voltage based)3 Fault Reason Type - Motor fault (Current based)4 Tripped Status Bits - PTC5 Tripped Status Bits - Phase rotation mismatch6 Tripped Status Bits - Stall7 Tripped Status Bits - Overload8 Tripped Status Bits - Starts limit exceeded9 Tripped Status Bits - Low power10 Tripped Status Bits - High power11 Tripped Status Bits - Under current12 Tripped Status Bits - Frequency deviation slow13 Tripped Status Bits - Frequency deviation fast14 Tripped Status Bits - Voltage unbalance15 Tripped Status Bits - Voltage phase loss16 Tripped Status Bits - Power factor deviation17 Tripped Status Bits - Jam18 Tripped Status Bits - Instantaneous over current19 Tripped Status Bits - Current unbalance20 Tripped Status Bits - Current phase loss21 Tripped Status Bits - Ground current22 Motor Control Status - Motor at speed23 Motor Control Status - Ready24 Motor Control Status - Inhibited25 Motor Control Status - Warning26 Motor Control Status - Faulted27 Motor Control Status - Remote enabled28 Motor Control Status - Running 229 Motor Control Status - Running 130 Warning Status Bits - PTC31 Warning Status Bits - Phase rotation mismatch32 Warning Status Bits - Stall33 Warning Status Bits - Overload34 Warning Status Bits - Starts limit exceeded35 Warning Status Bits - Low power36 Warning Status Bits - High power37 Warning Status Bits - Under current38 Warning Status Bits - Frequency deviation slow39 Warning Status Bits - Frequency deviation fast
