Appendix C—Optional Communication CardsPower Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 295Fieldbus Motor Control WordThis control word applies to all Cyclic Modules with outputdata except the Motor Management Profile shown above.The Fieldbus Motor Control word is defined as follows:Bit 0: Run1Bit 1: Run2Bit 2: Switch To RemoteBit 3: Reset FaultBit 4: ReservedBit 5: Test TripBits 6-15: ReservedBit 2, the Switch To Remote bit is only active when the“Allow Remote Control Switch” parameter is Enabled.This parameter can be found in the Operation Modecategory, in the Advanced parameters. This feature onlyworks with the Fieldbus Motor Control word.The Motor Control bits cannot be assigned if the FieldbusMotor Control word is assigned.If the Motor Control bits are assigned, then the FieldbusMotor Control word should not be assigned. In addition,when the Motor Control bits are assigned, the first outputword to the C445 is a control word based on the bitassignments. Subsequent word assignments such asassigning the System Services or digital or analog outputwords actually begin with the second output word sent tothe C445.Module 2: Cyclic Module 2This profile includes one input byte. Each bit isselectable via the C445 GSD file installed in thePROFIBUS master’s configuration software tool.Module 3: Cyclic Module 3This profile includes 2 input bytes. Each bit isselectable via the C445 GSD file installed in thePROFIBUS master’s configuration software tool.Module 4: Cyclic Module 4This profile includes 1 output byte. The output data isunder the “Slave” module, after the ConfigurationParameters.Module 5: Cyclic Module 5This profile includes 2 output bytes. The output data isunder the “Slave” module, after the ConfigurationParameters.Module 6: Cyclic Module 6This profile includes 2 input bytes and 2 output bytes.The input data is selectable under the cyclic module inthe PROFIBUS master’s programming software. Theoutput data is under the “Slave” module, after theConfiguration Parameters.Module 7: Cyclic Module 7This profile includes 8 input bytes and 4 output bytes.The input data is selectable under the cyclic module inthe PROFIBUS master’s programming software. Theoutput data is under the “Slave” module, after theConfiguration Parameters.Module 8: Cyclic Module 8This profile includes total 6 output bytes and 10 inputbytes. The input data is selectable under the cyclicmodule in the PROFIBUS master’s programmingsoftware. The output data is under the “Slave”module, after the Configuration Parameters.Module 9: Cyclic Module 9This profile includes 2 input bytes. 1 word parametermay be selected for the input data. The input data isselectable under the module in the PROFIBUSmaster’s programming software.Module 10: Cyclic Module 10This profile includes 4 input bytes. 2 word parametersmay be selected for the input data. The input data isselectable under the module in the PROFIBUSmaster’s programming software.
