1-6 Notes on Using Your ServerInstallation, Relocation, Storage, and ConnectionWARNINGDisconnect the power cord(s) before installing or removing the server.Make sure to power off the server and disconnect the power cord(s) from apower outlet before installing/removing the server. All voltage is removedonly when the power cords are unplugged.CAUTIONNever attempt to lift the server only by yourself.Your server weighs max 26 kg (depending on its hardware configuration).Carrying the server only by yourself may strain your back. Hold the serverfirmly by its bottom with at least two or more people. Do not hold the frontmask to lift the server. The front mask may be disengaged from the server,causing personal injury.Do not install the server in any place other than specified.Do not install the server in the following places or any place other thanspecified in this manual. Failure to follow this instruction may cause a fire. a dusty place a humid place such as near a boiler a place exposed to direct sunlight an unstable placeDo not use the equipment in the place where corrosive gases exist.Make sure not to locate or use the server in the place where corrosive gases(sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone,etc) exist.Also, do not set it in the environment where the air (or dust) includescomponents accelerating corrosion (ex. sulfur, sodium chloride) orconductive metals. There is a risk of a fire due to corrosion and shorts of aninternal printed board.Do not connect any interface cable with the power cord of the server pluggedto a power source.Make sure to power off the server and unplug the power cord from a poweroutlet before installing/removing any optional internal device orconnecting/disconnecting any interface cable to/from the server. If the serveris off-powered but its power cord is plugged to a power source, touching aninternal device, cable, or connector may cause an electric shock or a fireresulted from a short circuit.
