4-12 Configuring Your ServerMemory Configuration submenuWhen [Memory Configuration] is selected in the Advanced menu and then the Enter key is pressed,the screen below is displayed. If an item with an arrow displayed to its left is selected and then theEnter key is pressed, a submenu is displayed.For details about the options, see the following table.Option Parameters DescriptionMemory Information – –Hardware MemoryTest[Disabled]EnabledSpecify whether to perform a memory test. SpecifyingEnable increases the POST startup time.Memory Retest [No]YesSpecify whether to clear the memory error informationand test all DIMMs on the next startup. After the nextstartup, this option is automatically switched to [No].Memory RAS Mode [Independent]MirroringLock StepSparingSpecify the memory RAS mode. For details about thisfeature. See Chapter 9 for details.Memory Frequency Auto800MHz1066MHz1333MHzSpecify the memory clock frequency.Memory Voltage Normal[Low]Specify the voltage at which the memory operates.Selecting Normal increases power consumption, butthe memory operation clock speeds up.NUMA Disabled[Enabled]Specify whether to enable or disable the Non-UniformMemory Access feature (displayed only in 2-CPUconfiguration).[ ]: Factory-set
