2-26 General DescriptionFlash FDDA Flash FDD is a device that has capacity compatibility with a floppy disk drive.One Flash FDD can be connected to a USB connector of this server. If a floppy disk drive isconnected to this server, be sure to disconnect it.CAUTIONBe extremely careful not to lose the Flash FDD or have it stolen.If the Flash FDD is lost, stolen, misappropriated, or fraudulently obtained,there is a risk of leaking confidential information to a third party. NECassumes no responsibility for damages caused by leaking confidentialinformation in this way.IMPORTANT: The status of the write protection switch of the Flash FDD frombefore it is connected to this server is applied. Therefore, flippingthis switch after connecting the Flash FDD has no effect. If it isnecessary to flip this switch during use, temporarily disconnect theFlash FDD from the server, and then flip the switch. Be careful not to accidently slide the write protection switch whileconnecting the Flash FDD to or disconnecting it from the server.NotesThe Flash FDD is only intended as a temporary means of performing processing such as readingdevice drivers during installation, so do not use the FDD to back up data.Compensation for recorded dataNEC will not pay compensation for data recorded on the Flash FDD if the data is lost.
