8-20 TroubleshootingMessages Displayed by RAID Controller during POSTOn-screen message ActionMemory/battery problems were detected.The adapter has recovered, but cacheddata was lost.Press any key to continue, or 'C' to load theconfiguration utility.Contact your service representative.Firmware version inconsistency wasdetected.The adapter has recovered, but cacheddata was lost.Press any key to continue, or 'C' to load theconfiguration utility.Contact your service representative.Foreign configuration(s) found on adapterPress any key to continue, or 'C' to load theconfiguration utility.Press C to run the utility to import or clearconfiguration.Previous configuration cleared or missingImporting configuration created onMM/DD hh:mmPress any key to continue, or 'C' to load theconfiguration utility.Contact your service representative.An enclosure was found that contains bothSAS and SATA drives, but this controllerdoes not allow mixed drive types in a singleenclosure. Please correct the problem thenrestart your system.Press any key to continue, or 'C' to load theconfiguration utility.RAID Controller may be faulty. Contact your servicerepresentative to replace the RAID controller.SAS drives were detected, but thiscontroller does not support SAS drives.Please remove the SAS drives then restartyour system.Press any key to continue, or 'C' to load theconfiguration utility.RAID Controller may be faulty. Contact your servicerepresentative to replace the RAID controller.SATA drives were detected, but thiscontroller does not support SATA drives.Please remove the SATA drives then restartyour system.Press any key to continue, or 'C' to load theconfiguration utility.RAID Controller may be faulty. Contact your servicerepresentative to replace the RAID controller.Invalid SAS topology detected. Pleasecheck your cable configurations, repair theproblem, and restart your system.Check if cable is connected properly. If the sameerror persists, contact your service representative.The battery hardware is missing ormalfunctioning, or the battery is unplugged.If you continue to boot the system, thebattery-backed cache will not function.Please contact technical support forassistance.Press 'D' to disable this warning (if yourcontroller does not have a battery).Press D to hide this message.Check if battery is connected properly. If the sameerror persists, contact your service representative.
