Troubleshooting 8-21On-screen message ActionYour VDs that are configured for write-backare temporarily running in write-throughmode.This is caused by the battery being charged,missing, or bad.Please allow battery to charge for 24 hoursbefore evaluating battery for replacement.The following VDs are affected :XXPress any key to continue.Ignore this message.Run WebBIOS or Universal RAID Utility to check ifbattery is detected.• Battery is not detected:– Check if battery is connected properly.– Battery may be insufficiently charged. Halt thesystem for 24 hours or longer and chargebattery.• Battery is detected:– Halt the system for 9 hours or longer andcharge battery.If the same error persists, contact your servicerepresentative.Invalid SAS Address present in MFC data.Please program valid SAS Address, andrestart your system.Contact your service representative.Some configured disks have been removedfrom your system, or are no longeraccessible. Please check your cables andalso ensure all disks are present.Press any key to continue, or 'C' to load theconfiguration utility.Check if cable and hard disk drives are connectedproperly. If the same error persists, contact yourservice representative.The following VDs have missing disks: xxIf you proceed (or load the configurationutility), these VDs will be marked OFFLINEand will be inaccessible.Please check your cables and ensure alldisks are present.Press any key to continue, or 'C' to load theconfiguration utility.The following VDs are missing: xxIf you proceed (or load the configurationutility), these VDs will be removed from yourconfiguration. If you wish to use them at alater time, they will have to be imported. Ifyou believe these VDs should be present,please power off your system and checkyour cables to ensure all disks are present.Press any key to continue, or 'C' to load theconfiguration utility.All of the disks from your previousconfiguration are gone. If this is anunexpected message, then please power offyour system and check your cables toensure all disks are present.Press any key to continue, or 'C' to load theconfiguration utility.
