General Description2-215.If the server has an optional RAID controller, POST displays the message prompting youto launch the WebBIOS Setup utility. (POST will automatically proceed a few secondslater.)Press for WebBIOSPressCtrl+Hto run the utility to configure the RAID System with hard disk drives. Fordetail explanation, see Chapter 4 for detail.When you exit the utility, a message prompting you to restart the system. PressCtrl+Alt+Del. The server automatically restarts POST all over again.6.If the POST detects the optional add-in card, it displays the message prompting you tolaunch the add-in card BIOS configuration utility. (You can ignore the message. POSTwill automatically proceed a few seconds later.)Press forSASSelect(TM) Utility!PressCtrl+Ato run the utility. Refer to the manual that comes with the optional add-incard for detail.7.After a while, POST displays the following message prompting you to launch the BIOSSETUP utility, stored in the mother board of the server. This message appears at bottomleft on the screen.Press to enter SETUPLaunch the BIOS SETUP utility when you need to change the settings to meet therequirements for the server. As long as the above message is not displayed with an errormessage, you don't have to launch the utility. (Ignore the message. POST willautomatically proceed.)To launch the BIOS setup utility, pressF2while the above message is displayed. SeeChapter 4 for setup and parameters.The server automatically restarts POST all over again when you exit the SETUP utility.8.If you set a password using the BIOS SETUP utility, the password entry screen appearsupon successful completion of POST.Up to three password entries will be accepted. Three incorrect password entries disablethe server to boot. In such a case, turn off the power and wait about ten seconds beforeturning on to boot the server.IMPORTANT:Do not set a password before installing an OS.9.The OS starts when POST completes.
