336 / Terminals&SetsModular ICS 7.1 Installer Guide N0130943 02Line assignmentThis setting allows you to assign physical trunks and targetlines to each telephone. Target lines are assigned and removedin the same manner as other lines.1. After you have chosen a set number, press ≠ andenter the line number.2. Press CHANGE to change the setting for each line to one ofthe following: Unassigned, Ring only, Appr&Ring, andAppr only.Telephones that are grouped together, and that are assignedmultiple target lines, can be set to allow ringing at alltelephones simultaneously (Broadcast ring).Tip - When you assign line access for BRI loops whichhave only one SPID, make sure that the programming for thetwo lines on a BRI loop is identical. For example, if line 001on BRI loop 201 appears at a DN, line 002 on the same loopshould appear at the DN as well. See the ISDN chapter formore information about programming BRI lines.In general, auto-answer loop start trunks and auto-answerBRI trunks are not assigned to telephones. If assigned, theyare used for monitoring incoming call usage, or for makingoutgoing calls.
