Services / 401N0130943 02 Modular ICS 7.1 Installer GuideSetting up a route for long distance callingInstaller password requiredAn office may have leased lines or E&M trunks which make itcheaper to call long distance.The routing should take place automatically when the numberof the outgoing call begins with 1.The first step is to build a route (under Services/RoutingService/Routing).1. At Route:, enter 002 (or any other available route number)2. Choose the line pool where the discounted lines for callinglong distance have been placed. Example: Line pool B.3. Then you need to assign the route to the destination codeand to the destination code schedules. (under Services/Routing Service/Dest Codes)4. At DstCode: enter a valid destination code.Example: 1403Refer to Dest codes on page 395.Tip - To view existing destination codes press ‘before entering a new code.Tip - The destination code can use a different routedepending on which schedule is being used. Refer to Servicesin the Modular ICS 7.1 System Coordinator Guide forinformation about using schedules. In the above example, thesystem uses Route 002, which uses Line pool B, to takeadvantage of the lower cost when the system is in normalmode.
