496 / HardwareModular ICS 7.1 Installer Guide N0130943 02HardwareHardware is where you view and change settings for cartridgesinstalled in the ICS, Trunk Modules, Station Modules, andData Modules.Show module Installer password requiredThe Show module setting automatically displays the modulesconnected to the system. Press ‘ to select the setting:KSU, Mod 03, Mod 04, Mod 05, Mod 06, Mod 07, Mod 08.Note: MICS-XC has a maximum of 14 modules.Cards on KSU Installer password requiredThe Cards on KSU setting allows you to specify the type ofTrunk Cartridges in the ICS.Press ‘ to select the setting: T1, PRI, BRI-U4,BRI-U2, BRI-ST, E&M, DID, or Loop.Note: KSU is also known as the Integrated CommunicationSystem (ICS).• Loop is the default setting used for Loop Start and CallInformation (CI) Trunk Cartridges.• Select the T1 or PRI setting for DTIs cards.Tips - You cannot change this setting unless you firstdisable the Trunk Cartridge using Module status inMaintenance.Remember to enable the Trunk Cartridge once you havecompleted programming. See Module status on page 537 fordetails. The Trunk Cartridge slots in the ICS are numberedfrom right to left.
