Services / 399N0130943 02 Modular ICS 7.1 Installer GuideSetting up a route for local calling Installer password requiredAn office may have different suppliers for local and longdistance telephone service. By programming a destinationcode, any call that begins with 9, the most common dialoutdigit, will automatically use lines dedicated to local service.The first step is to build a route (under Services/RoutingService/Routing).1. At Show route: enter 001 (or any other available routenumber)2. Press SCAN to view defined routes and press CLEAR to erasea defined route.3. Choose the line pool that contains the lines for localcalling.4. Enter the DialOut digits (if any) which are needed to directthe call once it is connected to an external line.Note: For local calls only, there are no DialOut numbers.Compare this with Setting up a route for long distancecalling on page 401.5. Now you need to set up a destination code that will use thisroute during the various schedules. Since users will dial 9to make an external call, 9 should be the destination code.(Services/Routing Service/Dest Codes)6. At Show DstCode: press ADD and enter 9.Tips - If entering a code other than 9, a valid destinationcode must be used. See Dest codes on page 395.To view existing destination codes press ‘ beforeentering a new code.
