Provisioning BRI and PRI lines / 563N0130943 02 Modular ICS 7.1 Installer GuideProvisioning BRI and PRI linesThis section discusses how you put BRI and PRI lines into andout of service.BRI and T1 lines Installer password requiredProvisioning applies to BRI and T1 loops and lines. It allowsyou to place loops and lines in or out of service, either beforeor after the BRI Cards have been installed in the ICS.When you provision a loop, ISDN terminals on the loop can beused to make outgoing calls or receive incoming calls(S or U-LT loop).Loop lines are also available for use by the devices attached tothe system (T, S, or U-NT loop). When you are configuring aT, S, or NT loop, you must also provision each line on the loopto place the lines in service.Cd1-ICSThe card type will appear with the setting. If no card has beeninstalled, you can change the card type under Hardware.1. Press ≠ to display the loops found on the card.2. Press REMOVE to take the loop out of service.3. If lines on the loop are busy, the display will ask if you stillwant to remove the loop from service.Press YES to go ahead.
