394 / ServicesModular ICS 7.1 Installer Guide N0130943 02When a PRI protocol is selected or changed, the Service Typeand Service ID fields are automatically cleared for each entryin the routing table for that PRI.Programming the PRI routing tableThe dialing plan must be thoroughly planned out in advancebefore programming the information into the Norstar system.Programming the routing table takes place in Services underRouting Service/Routes1. Press ≠. The display shows Show route.2. Press ‘. The display shows Rte001.3. Press ≠. The display shows Dial-Out:Nonumbr.4. Press CHANGE to enter a number (up to 24 digits).5. Press ‘. The display shows Use: Pool A.The PRI pool(s) displayed depend on how the PRI lines areput into pools in the Trunk/Line data section ofprogramming. It is possible to have only one PRI pooleven if there are two or three PRI cards in the system.6. Press ‘. The display shows SrvcType:Public.Press CHANGE to select a different Service Type.Note: This parameter displays for specific protocols,such as N12, DMS100, DMS250.7. Press ‘. The display shows Service ID:None.Press CHANGE to enter the Service ID number.This parameter displays for specific protocols, such asN12, DMS100, DMS250.8. Press ‘. The display shows DN type:Public.Press CHANGE to enter Public or Private.
