Module status / 539N0130943 02 Modular ICS 7.1 Installer GuideChecking the state of a cartridge Installer password requiredStart from the display that shows the number of linesconnected to the Trunk Cartridge you chose, for example,Card 1: 4 lines.1. Press STATE.The display shows the state of the cartridge. Someexamples of this display are shown in the previous table.2. Press ‘ or “ to check the TrunkCartridges connected to the other Trunk Modules.3. If required, you can disable or enable the cartridge. Referto Disabling a module or its cartridges on page 539 orEnabling a module or its cartridge on page 540.4. Press OK to return to the display showing how many linesare connected to the Trunk Cartridge.Disabling a module or its cartridgesInstaller password requiredFrom the display showing the state of the module or cartridge:1. Press DISABLE. Disable at once? displays.2. Press YES.The system disables the module or cartridge in one minute.If the status is idle, the system disables the module orcartridge immediately.Use Page feature prior to disabling.Use the Page feature to inform people that youare about to disable a module. Mention that theymay experience delays in the performance oftheir devices.
