426 / System prgrmingModular ICS 7.1 Installer Guide N0130943 02Programming the queue timeoutThis setting allows you to program the number of seconds acall will remain in the hunt group queue before it is also routedto the overflow position.1. When the display shows Member DNs:.2. Press ‘ until the display shows Q Timeout:.3. Press CHANGE to set the queue timeout: 15, 30, 45, 60,120 or 180.Programming the overflow setThis setting allows you to indicate a telephone to which thehunt group calls will be routed when the queue is full.• If the overflow telephone is not a hunt group member, thecall ceases to be a hunt group call once it transfers.• If the overflow telephone is a hunt group member, the callis treated as a new call and goes to the bottom of the queue.The assigned overflow position can also can be a DN numberassociated with a voice mailbox.1. When the display shows Member DNs:.2. Press ‘ until the display shows Overflow:.3. Press CHANGE to change the overflow position.4. Enter the new overflow set or mailbox number.
