2-76(2) Analog inputs 1 to 3 automatic offset adjustmentThis function automatically adjusts offset setting of analog input.Analog input 1 (AI1)......Pr4.22 (Analog input 1 (AI1) offset setup)Analog input 2 (AI2)......Pr4.25 (Analog input 2 (AI2) offset setup)Analog input 3 (AI3)......Pr4.28 (Analog input 1 (AI3) offset setup)RemarksNote• This function is invalid at position control mode.• You cannot write the data only by executing automatic offset adjustment.Execute a writing to EEPROM when you need to reflect the result afterward.• After completion of the automatic offset adjustment, return to SELECTION display byreferring to P.2-54 “Structure of Each Mode”.• When you execute automatic offset adjustment, makecommand input to 0V,then keep pressing until the displaychanges to .• Press to call forEXECUTION display.(SET button)Automatic offsetadjustment finishes.Automatic offset adjustment starts.* Example of Analog input1(AI1).Error occurs.Adjustmentfinishes.( Invalid mode is selected,)or offset value exceedsthe setup range of Pr4.22.“ ” increases while keeppressing (for approx. 5sec)as the right fig. shows.(SET button)SELECTION display EXECUTION display15. How to Use the Front PanelAuxiliary Function Mode (EXECUTION display)