Chapter 4 Settings ā [NETWORK] menu104 - ENGLISHError information pageWhen [Error (Detail)] appears in the self-diagnosis display of the [Projector status] screen, click it to display the error details.f The projector may go into the standby status to protect the projector depending on the contents of the error.11 Self-diagnosis result displayDisplays the item check results.[OK]:Indicates that operation is normal.[FAILED]:Indicates that there is a problem.[WARNING]:Indicates that there is a warning.r Problem occurrence [FAILED] itemsParameter Description[MAIN CPU BUS] There is a problem with the microcomputer circuitry. Consult your dealer.[FAN] There is a problem with the fan or the fan drive circuit. Consult your dealer.[INTAKE AIR TEMPERATURE] The air intake temperature is too high. The projector may be used in an operatingenvironment where the temperature is high, such as near a heating appliance.[OPTICS MODULE TEMPERATURE]The temperature around the optics module inside the projector is high. The projectormay be used in an operating environment where the temperature is high, such as near aheating appliance.[INTERNAL AIR TEMPERATURE] The temperature inside the projector is high. The projector may be used in an operatingenvironment where the temperature is high, such as near a heating appliance.[LIGHT STATUS] The light source failed to turn on or off. Wait a while until the light source cools off, andthen turn on the power.[INTAKE AIR TEMP.SENSOR] There is a problem with the intake temperature detection sensor. Consult your dealer.[OPTICS MODULE TEMP.SENSOR] There is a problem with the temperature detection sensor around the optics moduleinside the projector. Consult your dealer.[INTERNAL AIR TEMP.SENSOR] There is a problem with the sensor used to detect temperature inside the projector.Consult your dealer.[BATTERY] Replacement of built-in battery is required. Consult your dealer.[PHOSPHER WHEEL] There is a problem with the fluorescent wheel or fluorescent wheel drive circuit. Consultyour dealer.