Chapter 4 Settings — [PROJECTOR SETUP] menu86 - ENGLISHNotef When the Panasonic twisted-pair-cable transmitter (such as the optional digital interface box (Model No.: ET-YFB100G)) is connected to theprojector, its input name is reflected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reflected is selected, itis disabled.[RS-232C]Set the sending and receiving port of the serial command.Communicating using the terminal1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [INPUT SELECT].4) Press qw to switch [SERIAL].5) Press as to select [BAUDRATE].6) Press qw to switch [BAUDRATE].f The items will switch each time you press the button.[9600]Select the proper speed.[19200][38400]7) Press as to select [PARITY].8) Press qw to switch [PARITY].f The items will switch each time you press the button.[NONE]Select the parity condition.[EVEN][ODD]Communicating using the terminal1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [INPUT SELECT].4) Press qw to switch [DIGITAL LINK].5) Press as to select [PARITY].6) Press qw to switch [PARITY].f The items will switch each time you press the button.[NONE]Select the parity condition.[EVEN][ODD]When using existing projector control commandsSet each item when controlling the projector from a computer using control commands of a previously purchased Panasonic projector. ExistingPanasonic projector control software and other software can still be used.1) Press as to select [RS-232C].