Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 91[LOAD ALL USER DATA]Load the various setting values saved as a backup in the built-in memory of the projector.1) Press as to select [LOAD ALL USER DATA].2) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.4) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Notef The projector will go into the standby status to reflect the setting values when [LOAD ALL USER DATA] is executed.[INITIALIZE]Return various setting values to their factory default settings.1) Press as to select [INITIALIZE].2) Press the button.f The [SECURITY PASSWORD] screen is displayed.3) Enter a security password and press the button.f The [INITIALIZE] screen is displayed.4) Press as to select an item to initialize.[ALL USER DATA]Returns all setting items including [ENTRY SIGNAL], [NETWORK SETUP], [E-mail set up], and[USER LOGO] to factory default settings.The projector will go into the standby status to reflect the setting values.[ENTRY SIGNAL]Deletes all the setting values saved for each input signal.To delete only a part of a registered signal, perform the procedure described in “Deleting theregistered signal” (x page 94).[NETWORK/E-MAIL] Returns [NETWORK SETUP] and [E-mail set up] to factory default settings.[LOGO IMAGE] Deletes the image registered in [USER LOGO].5) Press the button.6) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.[SERVICE PASSWORD]This function is used by a service person.