| 
Chapter 3 Basic Operations — Switching on/off the projector36 - ENGLISHMaking adjustments and selectionsIt is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.3)2)1)2)1)4)1) Set the initial settings. (x page 20)f The initial setting screen is displayed when the projector is switched on for the first time after purchase as well as when [ALL USERDATA] in the [PROJECTOR SETUP] menu → [INITIALIZE] is executed.2) Press the input selection (, , select the input signal.3) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 28)4) If the input signal is an RGB signal, press the button.Switching off the projector1)3)2)4) 1) 2)1) Press the power <v/b> button.f The [POWER OFF(STANDBY)] confirmation screen is displayed.2) Press qw to select [OK], and press the button.(Or press the power <v/b> button again.)f Projection of the image stops.3) Wait for a few seconds until the power indicator of the projector body lights/flashes in red.4) Press the side of the switch to turn off the power.Notef Even when the power <v/b> button is pressed and the power is switched off, the projector consumes power if the main power ofthe projector is on.When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], the power consumption during standby can be conserved.f The power can be turned off by pressing the side of the switch while projecting or by directly using the breakerunder conditions where the switch of the projector cannot be switched off/on easily such as while mounting on the ceiling.However, the settings or adjustments performed right before the power is turned off may not be reflected. |
