Chapter 4 Settings — [ADVANCED MENU] menuENGLISH - 59Blanking correction Item Operation Adjustment Range of adjustmentLeft side of thescreen [LEFT]Press the w button. The blanking zonemoves to the right.Left and right: 0 (lowerlimit)Press the q button. The blanking zonemoves to the left.Right side of thescreen [RIGHT]Press the q button. The blanking zonemoves to the right.Press the w button. The blanking zonemoves to the left.[INPUT RESOLUTION]Adjust to achieve an optimal image when there is a flickering image or smeared outlines.1) Press as to select [INPUT RESOLUTION].2) Press the button.f The [INPUT RESOLUTION] screen is displayed.3) Press as to select [TOTAL DOTS], [DISPLAY DOTS], [TOTAL LINES], or [DISPLAY LINES], and pressqw to adjust it.f Values corresponding to the signal being input are displayed automatically for each item. Increase or decrease the displayed valuesand adjust to the optimal point viewing the screen when there are vertical stripes or sections are missing from the screen.Notef Previously mentioned vertical banding will not occur with all white signal input.f The image may be disrupted while performing the adjustment, but it is not a malfunction.f [INPUT RESOLUTION] can be adjusted only when an analog RGB signal is input to the terminal or the -I IN>terminal.f Certain signals may not be adjustable.[CLAMP POSITION]You can adjust the optimal point when the black part of the image is blunt or it has turned green.1) Press as to select [CLAMP POSITION].2) Press qw to adjust.Status Rough guide for optimal value Range of adjustmentThe black part is blunt. The point where bluntness of the black part improves the most isthe optimal value. 1 - 255The black part is green. The point where the green part becomes black, and the bluntnesshas improved is the optimal value.Notef [CLAMP POSITION] can be adjusted only when an analog signal is input to the terminal or the -I IN> terminal.f Certain signals may not be adjustable.[EDGE BLENDING]The edge blending function allows multiple projector images to be seamlessly overlapped by using the inclination of the brightness at theoverlapped area.1) Press as to select [EDGE BLENDING].2) Press qw to switch [EDGE BLENDING].f The items will switch each time you press the button.[OFF] Sets the edge blending function to off.[ON] Sets the edge blending function to on.f To adjust edge blending, proceed to Step 3).