Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 872) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [EMULATE].4) Press the button.5) Press as to select an item.[DEFAULT] RZ470 series, RW430 series, RZ370 series, RW330 series[D3500] D3500 series[D4000] D4000 series[D/W5k SERIES] D5700 series, DW5100 series, D5600 series, DW5000 series, D5500 series[D/W/Z6k SERIES] DZ770 series, DW740 series, DX810 series, DW730 series, DX800 series, DZ6710 series, DZ6700series, DW6300 series, D6000 series, D5000 series, DZ570 series, DW530 series, DX500 series[L730 SERIES] L730 series, L720 series, L520 series[L780 SERIES] L780 series, L750 series[L735 SERIES] L735 series[L785 SERIES] L785 series[F/W SERIES] FW430 series, FX400 series, FW300 series, F300 series, F200 series, FW100 series, F100 series[LZ370] LZ370 series[LB/W SERIES] LB3 series, LB2 series, LB1 series, ST10 series, LB90 series, LW80NT series, LB80 series, LB78series, LB75 series[VX500 SERIES] VW435N series, VW430 series, VX505N series, VX500 series, VW330 series, VX400NT series,VX400 series, VX41 series[EZ570 SERIES] EZ570 series, VW435N series, EW530 series, EX600 series, EX500 series[VW431D] VW431D series6) Press the button.7) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Notef Refer to “ terminal” (x page 127).f When [DIGITAL LINK] is selected, communication using that serial terminal is only available when the corresponding device (such as theoptional digital interface box (Model No.: ET-YFB100G)) is connected to the terminal.f When transferring logos via the optional digital interface box (Model No.: ET-YFB100G), “NO SIGNAL SLEEP” of ET-YFB100G must be setto “OFF” to avoid cutting off communication.f When [DIGITAL LINK] is selected, communication speed is fixed to 9 600 bps.[FUNCTION BUTTON]Display the functions that are currently assigned to the - buttons on the remote control. Also, cancel the assignedsettings.Canceling the assigned settings of the - buttons1) Press as to select [FUNCTION BUTTON].2) Press the button.f The [FUNCTION BUTTON] screen is displayed.3) Press as to select the function button (F1 - F3) in which assignment will be canceled.4) Press the button on the remote control.5) When the confirmation is displayed, select [OK] and press the button.Notef You can also cancel the assigned settings by displaying the on-screen menu, selecting the menu item to be canceled (main menu, sub-menu, or details menu), and then pressing any one of the corresponding - buttons for at least three seconds.