Chapter 4 Settings — [POSITION] menu56 - ENGLISHNotef When [ASPECT] is set to [NATIVE], [ZOOM] cannot be adjusted.When [ASPECT] is set to [NORMAL]1) Press as to select [ZOOM].2) Press the button.f The [ZOOM] screen is displayed.3) Press as to select [MODE].4) Press qw to switch [MODE].[INTERNAL] Enlarges the size within the aspect range set with [SCREEN FORMAT].[FULL] Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].5) Press as to select [INTERLOCKED].6) Press qw to switch [INTERLOCKED].[OFF] Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.[ON] Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally by unitsof 1.0 time.7) Press as to select [VERTICAL] or [HORIZONTAL].f If [ON] is selected, select [BOTH].8) Press qw to adjust.Notef When [ASPECT] is not set to [NORMAL], [MODE] is not displayed.[CLOCK PHASE]Adjust to achieve an optimal image when there is a flickering image or smeared outlines.1) Press as to select [CLOCK PHASE].2) Press qw or the button.f The [CLOCK PHASE] individual adjustment screen is displayed.3) Press qw to adjust.f Adjustment value will change between [0] and [31]. Adjust so that the amount of interference is at a minimum.Notef Optimal value may not be achieved if the output from the input computer is unstable.f Optimal value may not be achieved when there is a shift in the total dot numbers.f [CLOCK PHASE] can be adjusted only when an analog signal is input to the terminal or the -I IN> terminal.f [CLOCK PHASE] cannot be adjusted when a digital signal is input.f If you press w while the adjustment value is [31], the value will become [0]. If you press q while the adjustment value is [0], the value willbecome [31].