Chapter 3 Basic Operations — Projecting38 - ENGLISHViewing 3D imagesTo project/view 3D images, you need active shutter system 3D eyewear, 3D content, and devices that can play 3D content.The projector only supports frame packing system, side by side system, top and bottom system, and frame sequential system as 3D videosignal input.Other systems are not supported.The active shutter system 3D eyewear supports DLP Link system and VESA standard IR (Infrared) system. However, not all the 3D eyewearoperations have been verified.3D eyewear with DLP Link system supportYou can project/view 3D images using 3D eyewear that supports DLP Link through the following procedure.Turn on the projector.1) Turn on the 3D eyewear.2) Change projector settings to use the 3D eyewear.f To set, select [DLP Link] or [DLP Link + 3D SYNC] in the [3D SETTINGS] menu → [3D MODE].Notef Change the setting in the [3D SETTINGS] menu → [LEFT/RIGHT SWAP] → [DLP Link], if there is something wrong with 3D images.f The 3D eyewear that supports DLP Link operates by receiving synchronized signals of 3D images which are included in projection lightreflected on the screen, and images can be viewed in three dimensions.Depending on the conditions such as projection screen size, brightness of installation location, viewing distance, and brightness of the lightsource, synchronized signals may not be received properly and you may not view 3D images correctly.f To view 3D images using the 3D eyewear that supports DLP Link system, the 3D eyewear is required to be synchronized to the followingfrequency according to the vertical scanning frequency of 3D video signals. For 3D eyewear specifications, contact the companies of 3Deyewear.Vertical scanning frequency 3D eyewear supporting frequency60 Hz/120 Hz 120 Hz50 Hz/100 Hz 100 Hz24 Hz 96 HzAttentionf Read “Viewing 3D images” (x page 18) before projecting/viewing 3D images.3D eyewear with VESA standard IR (Infrared) system supportYou can project/view 3D images using 3D eyewear that supports VESA standard IR (Infrared) system through the following procedure.Turn off the projector.1) Connect the IR transmitter cable to the <3D SYNC> terminal on the projector.2) Turn on the projector, 3D eyewear, and IR transmitter.3) Change projector settings to use the 3D eyewear.f To set, select [3D SYNC] or [DLP Link + 3D SYNC] in the [3D SETTINGS] menu → [3D MODE].Notef Change the setting in the [3D SETTINGS] menu → [LEFT/RIGHT SWAP] → [3D SYNC], if there is something wrong with 3D images.Attentionf Read “Viewing 3D images” (x page 18) before projecting/viewing 3D images.