Chapter 4 Settings — [NETWORK] menuENGLISH - 99Notef The projector does not support 10BaseT Full/Half.When the projector is connected to a twisted-pair-cable transmitter1) Press as to select [DIGITAL LINK SETUP].2) Press the button.f The [DIGITAL LINK SETUP] screen is displayed.3) Press as to select [DUPLEX(DIGITAL LINK)].4) Press qw to switch the communication method.f The items will switch each time you press the button.[100BaseTX-Full] Full duplex communication method is set.[100BaseTX-Half] Half-duplex communication method is set.[AUTONEGOTIATION] The communication method is set automatically.5) Press as to select [STORE].6) Press the button.7) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.[DIGITAL LINK STATUS]Display DIGITAL LINK connection environment.1) Press as to select [DIGITAL LINK STATUS].2) Press the button.f The [DIGITAL LINK STATUS] screen is displayed.[LINK STATUS] Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.[HDMI STATUS] Either [NO HDMI], [HDMI ON], or [HDCP ON] is displayed.[SIGNAL QUALITY][SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes togreen, yellow, or red depending on that value.Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.f MAX/MIN: Maximum/minimum value of the amount of error.f Green (- 12 dB or lower) → Normal signal quality level.f Yellow (- 11 to - 8 dB) → Warning level where there is the possibility of noise introduced on thescreen.f Red (- 7 dB or higher) → Abnormal level where synchronization may be interrupted, or a signal maynot be received.[NETWORK SETUP]Perform the initial setting of the network before using the network function.1) Press as to select [NETWORK SETUP].2) Press the button.f The [NETWORK SETUP] screen is displayed.3) Press as to select an item, and change the settings according to the operation instructions of themenu.[PROJECTOR NAME] Change the setting when using a DHCP server.[DHCP] Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when notusing a DHCP server.[IP ADDRESS] Enter the IP address when not using a DHCP server.[SUBNET MASK] Enter the subnet mask when not using a DHCP server.[DEFAULT GATEWAY] Enter the default gateway address when not using a DHCP server.4) Press as to select [STORE], and press the button.