Chapter 6: Device Management1205. Power ON the Raritan power strip.6. Click to Device Settings > Serial Port to open the Serial Port page.7. Select the Power Strip Control radio button and click OK. Once thisis done, the Power menu is available on the Remote Console.Naming the Power Strip (Port Page for Power Strips)Once the KX II-101-V2 is connected to a Raritan remote power strip, theport is displayed on the Port page and you can open that port from thePort Configuration page. The Type and the Name fields areprepopulated. The following information is displayed for each outlet in thepower strip: Outlet Number, Name, and Port Association.Use this page to name the power strip and its outlets. All names can beup to 32 alphanumeric characters and can include special characters.Note: When a power strip is associated to a target server (port), theoutlet name is replaced by the target server name (even if you assignedanother name to the outlet).To name the power strip (and outlets):Note: CommandCenter Service Gateway does not recognize power stripnames containing spaces.1. Change the Name of the power strip to something you willremember.2. Change the (Outlet) Name if desired. (Outlet names default to Outletnumber.)3. Click OK.
