![Raritan Dominion KX II-101-V2 User Manual Manual pdf 131 page image](https://manuals-archive2.s3.amazonaws.com/4192384/b3baccd7d51f83f2a5e323dd568bfab6131f.jpg)
Chapter 6: Device Management123Analog KVM SwitchYou can configure a Raritan analog KVM switch to work with the KX II-101-V2.The KX II-101-V2's compatibility has been verified with the followingRaritan KVM switches: SwitchMan SW2, SW4 and SW8 Master Console MX416 and MXUSimilar products from Raritan or other vendors may be compatible butsupport is not guaranteed.Note: In order for the KX II-101-V2 to work with analog KVM switches,the switch hotkey that allows you to switch targets must be set to theScroll Lock default.To configure a Raritan analog KVM switch:1. Set the Host Interface on the Keyboard/Mouse Setup page to PS/2.If you don't do this and try to configure an analog KVM switch, youwill receive the error "PS/2 is needed to access the KVM Switch.Please enable PS/2 first!" on the Analog KVM Switch Configurationpage. See Keyboard/Mouse Setup (on page 105).2. Click Device Settings > Analog KVM Switch. The Analog KVMSwitch Configuration page opens.3. Select the Use Analog KVM Switch checkbox to enable the fields.4. Select the Raritan switch type from the Switch Type drop-down: Raritan MCC Raritan MX Raritan MXU Raritan Switchman5. In the Port Count field, enter the number of ports available based onthe switch type that is selected. Change the port count if needed oruse the default counts. The defaults of the switch selection anddefault port count, respectively, are: Raritan MCC - 8 Raritan MX - 16 Raritan MXU - 16 Raritan Switchman - 26. Select the Security Setting checkbox to enable the security.7. Enter the password used to access the KVM switch.