Chapter 2: Installation and Configuration19d. Enter the Gateway IP Address.e. Link-Local IP Address. This address is automatically assigned tothe device, and is used for neighbor discovery or when norouters are present. Read-Onlyf. Zone ID. Identifies the device the address is associated with.Read-Onlyg. Select an IP Auto Configuration option: None (Static IP) - this option requires you manually specify thenetwork parameters.This is the recommended option because the KX II-101-V2 is aninfrastructure device, and its IP address should not change.Select this option if you want to ensure redundant failovercapabilities should the primary Ethernet port (or the switch/routerto which it is connected) fail. If it fails, KX II-101-V2 switches tothe secondary network port with the same IP address, ensuringtheir is no interruption.If None is selected, the following Network Basic Settings fieldsare enabled: Global/Unique IP Address, Prefix Length, andGateway IP Address allowing you to manually set the IPconfiguration. Router Discovery - use this option to automatically assign IPv6addresses that have Global or Unique Local significance beyondthat of the Link Local, which only applies to a directly connectedsubnet.2. Next, configure DNS settings.Configure the DNS Settings1. Select Obtain DNS Server Address Automatically if DHCP isselected and Obtain DNS Server Address is enabled. When ObtainDNS Server Address Automatically, the DNS information provided bythe DHCP server will be used.2. If Use the Following DNS Server Addresses is selected, whether ornot DHCP is selected, the addresses entered in this section is usedto connect to the DNS server.Enter the following information if the Following DNS ServerAddresses is selected. These addresses are the primary andsecondary DNS addresses used if the primary DNS serverconnection is lost due to an outage.a. Primary DNS Server IP Addressb. Secondary DNS Server IP Address3. When finished, click OK.Your KX II-101-V2 device is now network accessible.
