100 CHAPTER 7: IP A DDRESS CONFIGURATION COMMANDSParameterinterface-type interface-number: interface-type refers to the interface type, andinterface-number refers to the interface number. Refer to the interface commandin Port Command Manual for more information.DescriptionUse the display ip interface command to display information about an interface.Example# Display the information about interface VLAN-interface 1. display ip interface vlan-interface 1Vlan-interface1 current state : DOWNLine protocol current state : DOWNInternet Address is 1.1.1.1/8 PrimaryBroadcast address : 1.255.255.255The Maximum Transmit Unit : 1500 bytesinput packets : 0, bytes : 0, multicasts : 0output packets : 0, bytes : 0, multicasts : 0TTL invalid packet number: 0ICMP packet input number: 0Echo reply: 0Unreachable: 0Source quench: 0Routing redirect: 0Echo request: 0Router advert: 0Router solicit: 0Time exceed: 0IP header bad: 0Timestamp request: 0Timestamp reply: 0Information request: 0Information reply: 0Netmask request: 0Netmask reply: 0Unknown type: 0DHCP packet deal mode: globalTable 11 Description on the fields of the display ip interface commandField DescriptionVlan-interface1 current state Current state of the VLAN interface 1Line protocol current state Current state of the Line protocolInternet Address IP addressBroadcast address Broadcast addressThe Maximum Transmit Unit Maximum transmission unitinput packets : 0, bytes : 0, multicasts : 0output packets : 0, bytes : 0, multicasts : 0The number of the input/output unicastpackets, bytes and broadcast packets are all 0TTL invalid packet number The number of the received packets withinvalid TTLs
