Configuration File Management Commands 73the system software actually used for the current enabling, the filename of thesystem software configured for the next enabling, the configuration filename usedfor the current enabling, the configuration filename configured for the nextenabling.Related command: startup saved-configuration.Example# Display the filenames related to the current and the next enabling. display startupMainBoard:Startup saved-configuration file: flash:/8500.cfgNext startup saved-configuration file: flash:/8500.cfgresetsaved-configurationSyntaxreset saved-configurationViewUser viewParameterNoneDescriptionUse the reset saved-configuration command to erase configuration files fromthe flash memory of the switch.Perform this command with cautious. It is suggested to consult technical supportpersonnel first.Generally, this command is used in the following situations:■ After upgrade of software, configuration files in flash memory may not matchthe new version’s software. Perform the reset saved-configuration commandto erase the old configuration files.■ If a used switch is applied to the new circumstance and the originalconfiguration files cannot meet the new requirements, the switch should beconfigured again. Erase the original configuration files for reconfiguration.If the configuration files do not exist in the flash memory when the switch iselectrified and initialized, it will enter setup switch view automatically.Related command: save, display current-configuration, displaysaved-configuration.Example# Erase the configuration files from the flash memory of the switch. reset saved-configurationThe saved configuration will be erased.Are you sure?[Y/N]