OSPF Configuration Commands 425display ospf cumulative Syntaxdisplay ospf [ process-id ] cumulativeViewAny viewParameterprocess-id: Process ID of OSPF. The command is applied to all current OSPFprocesses if you do not specify a process ID.DescriptionUse the display ospf cumulative command to view the OSPF cumulativeinformation.Example# Display the OSPF cumulative information. display ospf cumulativeOSPF Process 1 with Router ID 1.1.1.1CumulationsIO StatisticsType Input OutputHello 225 437DB Description 78 86Routing preference Routing preference of OSPF. The internal route of OSPF includesintra/inter area route, and its default routing preference is 10.While that of the external route of OSPF is 150 by defaultDefault ASE parameters Default ASE parameters of OSPF, including metric, type and tagSPF computation count SPF computation count since OSPF is enabledArea Count Areas for connection to this routerNssa Area Count Number of NSSA areasSPF scheduled SPF scheduled (flag)Interface Interface name belonging to this areaCost Cost of routesState State informationType Network type of OSPF interfacePriority PriorityDesignated Router IP address of designated router (DR)Backup DesignatedRouterIP address of backup designated router (BDR)TimersOSPF timers, defining as follows:Hello Interval of hello packetDead Interval of dead neighborsPoll Interval of pollRetransmit Interval of retransmitting LSATransmit Delay Delay time of transmitting LSATable 56 Description of the fields of the display ospf brief commandField Description
