PoE Configuration Commands 883undo poe enable slot slot-numViewSystem viewParameterslot-num: Number of the slot where the module resides.DescriptionUse the poe enable slot command to enable PoE on a module.Use the undo poe enable slot command to disable PoE on a module.By default, PoE is disabled on a module.The switch checks that the total power of the current system is sufficient beforeallowing you to enable PoE on the module by using this command.Example# Enable PoE on the module in slot 2.[SW8800]poe enable slot 2# Disable PoE on the module in slot 2.[SW8800]undo poe enable slot 2poe legacy enable slot Syntaxpoe legacy enable slot slot-numundo poe legacy enable slot slot-numViewSystem viewParameterslot-num: Number of the slot where the module resides.DescriptionUse the poe legacy enable slot command to enable the module to detect thecompatibility of the PD connected to it.Use the undo poe legacy enable slot command so that the module does notdetect the compatibility of the PD connected to it.When detecting the compatibility of PDs, the module can detect and power thePDs incompatible with the 802.3af standard.By default, the module does not detect the compatibility of the PD connected to it.c CAUTION: Detecting an incompatible device slows down the detection anddecreases system performance; therefore, you are not recommended to enablecompatibility detection if the device connected is 802.3af-compliant.
