134 CHAPTER 10: E THERNET PORT CONFIGURATION COMMANDSdisplay jumboframeconfigurationSyntaxdisplay jumboframe configurationViewAny viewParameterNoneDescriptionUse the display jumboframe configuration command to view the Jumbo frameconfiguration on all cards. The supported Jumbo frame length ranges, as well asthe default values, may vary from card to card.Example# Display the current Jumboframe configuration in the system.system-view[SW8800] display jumboframe configurationThe jumboframe configuration at present:Slot 2:Allow jumbo frame to passThe Maximum Frame Length is 1552display port Syntaxdisplay port { hybrid | trunk }ViewAny viewInput(total): 0 packets, 0 bytes0 broadcasts, 0 multicastsInput(normal): 0 packets, 0 bytes- broadcasts, - multicastsInput: 0 input errors, 0 runts, 0 giants, 0throttles, 0 CRC0 frame, 0 overruns, - aborts, 0 ignored, -parity errorsOutput(total): 0 packets, 0 bytes0 broadcasts, 0 multicasts, 0 pausesOutput(normal): 0 packets, 0 bytes- broadcasts, - multicasts, 0 pausesOutput: 0 output errors, - underruns, - bufferfailures0 aborts, 0 deferred, - collisions, 0 latecollisions- lost carrier, - no carrierThe statistics information of input/outputpackets and errors on this port. "-" indicatesthat the item doesn’t supported by the switch.Table 19 Description on the fields of the display interface commandField Description