Kompella MPLS L2VPN Configuration Commands 771ViewSystem viewParametervpn-name: Name of the VPN, which must be unique in the PE. This argument is 1to 20 characters in length.encapsulation: User access encapsulation type. Two types are supportedcurrently: Ethernet access and VLAN access.DescriptionUse the mpls l2vpn encapsulation command to create a Kompella MPLS L2VPN,specify the encapsulation type, and enter MPLS L2VPN view.Use the undo mpls l2vpn command to remove a Kompella MPLS L2VPN.Related command: ce, mtu.n You can create a Kompella MPLS L2VPN only after you enable MPLS L2VPN. AllL2VPN parameters are configured in L2VPN view.Example# Create a Kompella MPLS L2VPN, with the name of 3Com, the encapsulationtype of Ethernet.[SW8800] mpls l2vpn 3com encapsulation ethernet[3Com-mpls-l2vpn-3com]mtu Syntaxmtu mtuViewMPLS L2VPN viewParametermtu: Layer 2 MTU (maximum transmission unit) of the VPN. This argument rangesfrom 0 to 10,200 and the default value is 1,500.DescriptionUse the mtu command to set the MTU for the Kompella MPLS L2VPN.The same MTU value must be configured for all the PE devices of the same VPN tomake sure that the configuration is valid.Related command: mpls l2vpn encapsulation.Example# Set the MTU of the VPN named vpna to 1,000.[SW8800] mpls l2vpn vpna encapsulation vlan[3Com-mpls-l2vpn-vpna] mtu 1000
